=========kosong=
Home » » Reset the Ink Level for Canon MX300

Reset the Ink Level for Canon MX300

Solution to reset the ink level for Canon MX300. The methode get from printer forum
  1. Disconnect the power cable
  2. Connect it while holding down the power button
  3. With the power button still down, press twice the "Cancel/Stop" red button
  4. Release the power button
  5. The printes turns into a kind of factory mode...(wait for about 10 seconds, utils it says "Idle")
  6. Press the ">" (next to the "OK" button) once."Shipping Mode 3"
  7. Press the "OK" button.
  8. Press "OK" again for "Without cleaning"
  9. A test page will print..
  10. Open the cover, like you are about to change the cartridges.
  11. Disconnect the power cable again.
  12. Take out both cartridges.
  13. Close the cover.
  14. Connect the power cable once again.
  15. Turn the printer on.
  16. Now just put the cartridges back...
Label:

2 comments:

  1. UnknownJune 24, 2009 at 11:06 AM

    This doesn't work for me. I get to stage 5 and the printer says "Factory Setting 1" but it doesn't change to "Idle", even after 10 minutes. None of the buttons work at this stage :(

    ReplyDelete
  2. UnknownOctober 6, 2009 at 9:44 AM

    me too. it switches to idle if i have removed the cartridge but then it cannot print

    ReplyDelete

Subscribe to: Post Comments (Atom)